ICC-ES AC308 PDF

ICC-ES AC Interim Criteria for Inspection and Verification of Concrete and Reinforced and Unreinforced Masonry Strengthening Using Fiber-reinforced. Accordance with. ICC-ES AC ADVANTAGES. DESCRIPTION/SUGGESTED SPECIFICATIONS*. The % epoxy resin and hardener are completely mixed. As such, Hilti maintains ICC-ES evaluation reports for adhesive anchors in concrete according to AC and in masonry according to AC I hope I have.

Author: Meztirn Brabar
Country: Bahamas
Language: English (Spanish)
Genre: Love
Published (Last): 12 January 2008
Pages: 151
PDF File Size: 3.22 Mb
ePub File Size: 14.10 Mb
ISBN: 730-8-96237-228-2
Downloads: 69139
Price: Free* [*Free Regsitration Required]
Uploader: Kigor

Traffic Engineering Council Committee. National Institute of Standards and Technology.

AC308 – Post-installed Adhesive Anchors in Concrete Elements

Adhesive anchor design provisions for tension were the av308 provisions supplemented, necessitating new checks for concrete bond stress. To provide the mechanical interlock to the concrete, the screw anchor cuts a thread into the concrete during the installation process. International Organization for Standardization.

Adhesive anchors were incorporated into ACI under the premise that the existing design models would be minimally affected.

Based partially on the Boston Big Dig tunnel accident, the adhesive anchor installer must be certified to install anchors in certain orientations and under certain load conditions. American Society of Safety Engineers. For post-installed mechanical anchors, anchors must be qualified to the criterion in the ACI Geosynthetic Institute Test Methods and Standards.

This makes the use of ac30 anchors a single-use item; removing and reusing the screw anchor in the drilled icc–es is not advised because the cutting threads on the screw are worn and getting the screw threads into the original cut threads in the concrete is difficult.

  CHESS ENDINGS ESSENTIAL KNOWLEDGE BY YURI AVERBAKH PDF

Pullout failures also occur for screw anchors only when they are deeply embedded. This requirement is recognition by the ACI Code committee that adhesive anchor installation needed some oversight qualifications to achieve satisfactory installations, consistent with the written design xc308 and anchor manufacturer installation instructions.

Idc-es Engineering Society of North America. There are a wide variety of post-installed concrete anchors, and the newest post-installed anchor is the screw anchor.

American Society of Mechanical Engineers. Institute of Electrical and Electronics Engineers. Infraguide of Best Practices. In ArticlesInSights Comments 0. British Board of Agrement. Code of Federal Regulations. Formal concrete anchorage design provisions first appeared in ACI as Appendix D, with applications limited to cast-in-place anchors and post-installed mechanical expansion anchors. Ontario Statutes, Regulations, etc. Deutsches Institut fur Normung e. They are intended to carry direct tension, direct shear, or combinations of tension and shear loadings.

Leave a Comment Click here to cancel reply. As of 15 Januarythe following actions were taken: National Electrical Manufacturers Association. Erosion Control Technology Council. American Wood Protection Association. Although the design procedure for screw anchors has not been codified, they are gaining acceptance in building practice ifc-es a reliable fastening element Olsen, et.

Ready Mixed Concrete Association of Ontario. American Water Works Association.

Deep embedments are often difficult to achieve because icf-es friction of cutting a thread can exceed the torsional capacity of the screw shank and fail the steel in torsion. In reality, screw anchors have been around since the early s. The new structural building code ACI will be re-organized based on member type. As of 15 Januarythe following will be required: Pullout failures look very much like bond failures for adhesively bonded anchors.

  LORNA AZPIRI PDF

Underwriters’ Laboratories of Canada. Design Provisions Adhesive anchors were incorporated into ACI under the premise that the existing aac308 models would be minimally affected. Ministere des transports du Quebec MTQ.

National Fire Protection Association. Reference should be made to a paper by Hoermann-Gast for additional information. Muncipal Engineers Association of Ontario.

STRUCTURE magazine | Post-Installed Anchors

Strategic Highway Research Program. Certification Based partially on the Boston Big Dig tunnel accident, the adhesive anchor installer must be certified to install anchors in certain orientations and under certain load conditions. International Concrete Repair Institute.

Goods and Services Identification Number. In addition to installer certification, inspection is an important requirement required in ACI So, what is the state of the anchoring industry and where do the codes go from here? Research testing of screw anchors has shown that failure can occur in tension via three modes: